Chapter 3 Using the console interface 239Using the Business Policy Switch 2000 Version 1.2Table 43 describes the Renumber Stack Units screen options.Hardware Unit Information screenThe Hardware Unit Information screen (Figure 88) lists the switch models,including any installed MDA and Cascade modules, that are configured in yourstandalone or stack configuration. In addition, this screen displays the softwareversion running on the hardware.To open the Hardware Unit Information screen:➨ Choose Display Hardware Units (or press h) from the main menu.Table 43 Renumber Stack Units screen optionsOption DescriptionCurrent Unit Number Read-only fields listing the current unit number of each of the configured stackunits. The entries in this column are displayed in order of their current physicalcabling with respect to the base unit, and can show nonconsecutive unit numberingif one or more units were previously moved or modified. The entries can alsoinclude unit numbers of units that are no longer participating in the stack (notcurrently active).MAC Address Read-only field listing the MAC address of the corresponding unit listed in theCurrent Unit Number field.New Unit Number User-settable field showing the current unit number of each unit in the stack. Youcan change any of the fields, as required. You can also delete entries by typingzero (0) or using the space bar to clear the field.Default Value Current stack orderRange 1 to 8Renumber units withnew setting?Specifies whether to start the renumbering process (default is No). Use thespacebar to toggle the selection to Yes.Renumbering resets the switch with the current configuration values. When youselect this option, the switch resets, runs a self-test, then displays the NortelNetworks logo screen. After you press [Ctrl]-Y at the screen prompt, the consolescreen temporarily displays the (standalone) Business Policy Switch main menu.Then, within 20 seconds, the console screen refreshes and displays the mainmenu screen for the stack configuration. The Unit LEDs display the new numberingorder.Default Value NoRange No, Yes
