Nortel IP Phone 2004 Page 109 of 430IP Phones Description, Installation, and OperationStatic IP address assignmentDuring the installation, the IP Phone 2004 parameters are entered manuallyusing the key pad.Your system administrator provides the following information: IP address,subnet mask, and default Gateway.You must also enter the Connect Server parameters including: IP address,port number, action, and retry count.Go to Procedure 18, “Installing an IP Phone 2004 for the first time usingmanual configuration” on page 110.Dynamic IP address assignment — Partial DHCPFor a partial DHCP installation, you must provide, through the IP Phone’skey pad, the Connect Server parameters including: IP address, port number,action, and retry count. Other parameters (IP Phone IP address, subnet mask,and default Gateway) are retrieved from the DHCP server.The IP Phone password, node ID and TN must be entered manually from thekey pad.For more information about DHCP servers, see Converging the DataNetwork with VoIP (553-3001-160).Go to Procedure 19, “Installing an IP Phone 2004 for the first time usingDHCP” on page 116.Dynamic IP address assignment — Full DHCPFor a full DHCP installation, all parameters (IP Phone IP address, subnetmask, default Gateway, Connect Server IP address, port number, action, andretry count) are retrieved from the DHCP server to recognize theIP Phone 2004.The IP Phone 2004 password, node ID and TN must be entered manuallyfrom the key pad.
