Nortel IP Phone 2001 Page 43 of 430IP Phones Description, Installation, and Operation5 Power the IP Phone 2001 using either the Power over Ethernet or an ACpower transformer (local power).If local power is used, plug the AC power transformer into the nearestpower outlet. Make sure you use the correct AC power transformer isused. The voltage rating of the transformer must match the wall outletvoltage. Refer to Table 4 on page 37. Connect the transformer to theAC power jack shown in Figure 3 on page 42. Be sure to thread thecord around the retaining hook to provide strain relief for a securepower connection.6 When the Nortel logo appears in the middle of the display, immediatelypress the four feature keys at the bottom of the display in sequence fromleft to right.7 At the prompt EAP enable?, select Yes. Enter DeviceID and Password.For more information on EAP, refer to Appendix C: “802.1x Port-basednetwork access control” on page 361.Note: If you select No, you will not be prompted to enter Device ID andPassword.8 At the prompt DHCP Yes/No?, select No.9 Enter the following information provided by your system administrator:IMPORTANT!Timing informationThere are only four seconds between plugging in the IP Phone 2001power transformer and the appearance of the Nortel logo in the middleof the display. When you see the logo, you have one second to respondby pressing the four feature keys at the bottom of the display insequence from left to right. If you miss the one-second response time,the IP Phone 2001 attempts to locate the connect server. Wait until it isfinished, and then begin the power-up sequence again.Screen prompt Descriptionset IP A valid IP Phone 2001 IP addressnet msk A subnet maskdef gw The default Gateway for the IP Phone 2001 onthe LAN segment to which it is connected
