Page 130 of 430 Nortel IP Phone 2007553-3001-368 Standard 7.00 August 2005IntroductionThis section explains how to install and maintain the IP Phone 2007. Forinformation on using the IP Phone 2007, see the IP Phone 2007 User Guide.This section contains the following procedures:• Procedure 25, “Pre-installation checklist” on page 149.• Procedure 26, “Installing an IP Phone 2007 for the first time usingmanual configuration” on page 151.• Procedure 27, “Installing an IP Phone 2007 for the first time usingDHCP” on page 158.• Table 28,”'Disabling Auto Negotiate and enabling Full Duplex mode” onpage 167.• Table 29, “Checking Ethernet Statistics” on page 167.• Procedure 30, “Changing the TN of an existing IP Phone 2007” onpage 169.• Procedure 31, “Replacing an IP Phone 2007” on page 170.• Procedure 32, “Removing an IP Phone 2007 from service” on page 170.Note: After an IP Phone has been installed and configured, if power tothe phone is interrupted, re-entry of the IP parameters, Node Number,TN, or re-acquisition of firmware is not required.DescriptionThe IP Phone 2007 brings voice and data to the desktop environment. Itconnects directly to the LAN through the Ethernet connection.The IP Phone 2007 translates voice into data packets for transport usingInternet Protocol. A Dynamic Host Configuration Protocol (DHCP) servercan be used to provide information that enables the IP Phone 2007 networkconnection, and connection to the Voice Gateway Media Card. TheIP Phone 2007 uses the customer’s IP network to communicate with the CallServer.
