Nortel 4500 Series Overview-system Configuration

Also see for 4500 Series: Cli manual Installation guide Installation

Contents

Nortel 4500 Series Overview-system Configuration Manual pdf 160 page image

160 Power over Ethernet"poe-limit parameters" (page 160) outlines the parameters for this command.poe-limit parametersParameter Descriptionport The ports to set the limit on<3 - 16> The power range to limit at from 3 to 16 WRun the poe-limit command in Interface Configuration command mode.Set traps controlThe poe-trap command enables PoE-related traps for PoE-enabled ports.The syntax for the poe-trap command ispoe poe-trap [unit <1-8>]Substitute <1-8> with the number of the unit on which to enable traps.Show main power statusThe show poe-main-configuration command displays the powerconfiguration.The syntax for the show poe-main-configuration command isshow poe-main-status [unit <1-8>]Substitute <1-8> with the number of the unit for which to display theconfiguration.Run the show poe-main-status command in Privileged EXECcommand mode.Set power usage thresholdThe poe-power-usage-threshold command sets the power usagethreshold in percentage on individual units.The syntax for the poe-power-usage-threshold command ispoe poe-power-usage-threshold [unit <1-8>] <1-99>Nortel Ethernet Routing Switch 4500 SeriesOverview — System ConfigurationNN47205-500 02.01 Standard5.0 23 February 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.