Configuring LLDP using the CLI 255LLDPDU and TLV error handling LLDPDUs and TLVs that containdetectable errors are discarded. TLVs that are not recognized, but that alsocontain no basic format errors, are assumed to be validated and are storedfor possible later retrieval by network management.Configuring LLDP using the CLIYou can enable and configure LLDP using the CLI. For more informationabout LLDP, see "Link Layer Discover Protocol (IEEE 802.1ab) Overview"(page 251). This section covers the following commands:• "lldp command" (page 255)• "lldp port command" (page 256)• "lldp tx-tlv command" (page 257)• "lldp tx-tlv dot1 command" (page 257)• "lldp tx-tlv dot3 command" (page 258)• lldp location-identification coordinate-base command• lldp location-identification civic-address command• "show lldp command" (page 262)• "default lldp command" (page 258)• "default lldp port command" (page 259)• "default lldp tx-tlv command" (page 259)• "default lldp tx-tlv dot1 command" (page 260)• "default lldp tx-tlv dot3 command" (page 261)• "no lldp port command" (page 261)• "no lldp tx-tlv command" (page 262)• "no lldp tx-tlv dot1 command" (page 262)• "no lldp tx-tlv dot3 command" (page 262)• "show lldp port command" (page 264)• "LLDP configuration example" (page 264)lldp commandThe lldp command sets the LLDP transmission parameters. The syntaxfor the lldp command islldp [tx-interval <5-32768>] [tx-hold-multiplier<2-10>] [reinit-delay <1-10>] [tx-delay <1-8192>][notification-interval <5-3600>] ]Run the lldp command in Global Configuration command mode.Nortel Ethernet Routing Switch 4500 SeriesOverview — System ConfigurationNN47205-500 02.01 Standard5.0 23 February 2007Copyright © 2007, Nortel Networks Nortel Networks Confidential.
