112 Configuring static link aggregationVlanIds dialog box10 Select a VLAN ID to add to the link aggregation group.11 Click OK.The VlanIds dialog box closes. The VLAN type is added to theVlanIds field of the MLT, Insert MultiLink Trunks dialog box.12 Clear the NtStgEnable check box if you prefer to use theCisco-compatible mode of Spanning Tree. See "Spanning Treemodes" (page 28) for information about NTSTG.13 Click Insert.The link aggregation group is added to the MultiLink Trunks tab ofthe MLT dialog box.14 Click Apply.The link aggregation group is added.—End—Table 22 "MLT dialog box - MultiLink Trunks fields" (page 112)defines theMultiLink Trunks tab fields.Table 22MLT dialog box - MultiLink Trunks fieldsField DescriptionId A value that uniquely identifies the link aggregationgroup.• For Gigabit Ethernet and 10 Gigabit Ethernet ports,up to 7 MLTs (IDs 1–7) are supported.• For FastEthernet ports, up to 31 MLTs (IDs 1–31)are supported.PortType Specifies the port type: access or trunk port.Nortel Ethernet Routing Switch 8300Configuration — VLANs, Spanning Tree, and Static Link Aggregation using Device ManagerNN46200-510 03.01 Standard4.0 27 August 2007Copyright © 2005-2007, Nortel Networks.
