120 Configuring static link aggregationTable 25 "Statistics, MLT dialog box - Interface Utilization tab fields" (page120) defines the fields on the Interface Utilization tab.Table 25Statistics, MLT dialog box - Interface Utilization tab fieldsField DescriptionInOctets The total number of octets received on the MLT interface,including framing characters.InUtil Percentage of MLT interface in use for incoming data duringthe specified interval.OutOctets The number of packets delivered by this MLT to higherlevel protocols that were not addressed to a multicast orbroadcast address at this sublayer.OutUtil Percentage of MLT interface in use for outgoing data duringthe specified interval.Configuring SMLTThis section describes how to configure Split MultiLink Trunking (SMLT)and includes the following topics:• "Adding an MLT-based SMLT" (page 120)• "Viewing MLT-based SMLT information for the switch" (page 121)• "Configuring a single port SMLT" (page 122)• "Viewing single port SMLTs configured on the switch" (page 123)• "Deleting a single port SMLT" (page 124)• "Configuring an IST MLT" (page 124)• "Removing an IST MLT" (page 125)• "Viewing IST statistics" (page 126)Adding an MLT-based SMLTYou can create an SMLT from the Multilink Trunks tab by selecting the MLTtype as SMLT and then specifying an SMLT ID.To add an MLT-based SMLT:Step Action1 From the Device Manager menu bar, select VLAN > MLT .The MLT dialog box appears with the MultiLink Trunks tab selected.See "Multilink Trunks tab on the MLT dialog box" (page 121).Nortel Ethernet Routing Switch 8300Configuration — VLANs, Spanning Tree, and Static Link Aggregation using Device ManagerNN46200-510 03.01 Standard4.0 27 August 2007Copyright © 2005-2007, Nortel Networks.
