114 Configuring static link aggregationThe MLT dialog box appears and displays active link aggregationgroups. See "MLT dialog box - MultiLink Trunks tab" (page 110). Forfield definitions, see Table 22 "MLT dialog box - MultiLink Trunksfields" (page 112).2 Double-click the PortMembers field for the group you want to addports to.The MltPortMembers dialog box appears. See "MltPortMembersdialog box" (page 111).Ports currently assigned to the selected link aggregation group areselected. Available ports are editable.3 In the MltPortMembers dialog box, do one of the following:• To add individual ports, click the port numbers to add.• To add all ports in a module, click the slot number.• To add all ports, click All.Up to eight ports of the same type can belong to a single linkaggregation group.4 Click OK.The MltPortMembers dialog box closes. The port numbers areadded to the selected group on the MultiLink Trunks tab of the MLTdialog box.5 Click Apply.The ports are added to the link aggregation group.—End—Viewing link aggregation interface statisticsTo view link aggregation interfacestatistics:Step Action1 Select VLAN > MLT from the Device Manager menu bar.The MLT dialog box appears and displays active link aggregationgroups. See "MLT dialog box - MultiLink Trunks tab" (page 110).2 Click in the row of a link aggregation group to select it..The Graph button is activated.3 Click the Graph button.Nortel Ethernet Routing Switch 8300Configuration — VLANs, Spanning Tree, and Static Link Aggregation using Device ManagerNN46200-510 03.01 Standard4.0 27 August 2007Copyright © 2005-2007, Nortel Networks.
