Chapter 13 Using Telset Administration to set the basic parameters 129BCM50 Installation and Maintenance Guide4 Press OK.5 Press CHNGE to modify the IP settings. The display screen shows if DHCP is enabled ordisabled.6 Do one of the following:a If DHCP is currently enabled:• Press DIS to disable DHCP. You have the option to modify the IP Address, Subnet Mask,and Default Gateway. However, these settings have no effect as long as the system isdisabled.• Press IP to modify the following IP settings:— IP Address— Subnet Mask— Default Gatewayb If DHCP is currently disabled:• Press ENL to enable DHCP. The system must reboot to enable DHCP.• Press IP to modify the IP settings. You have the option to modify the IP Address, SubnetMask, and Default Gateway. However, these settings have no effect as long as the systemis disabled.7 Press Back to reboot the system.To configure the modem1 Select Feature 9*8 from a two-line display telephone.2 Enter the following user ID and password:User ID: SETNNAPassword: CONFIGThe numerical values of the user ID and password are 738662 and 266344, respectively.3 Press NEXT to scroll through the menu and select Modem.4 Press OK. The display screen shows if the modem is enabled or disabled.5 Do one of the following:a If the modem is disabled, press ENL to enable the modem.b If the modem is enabled, press DIS to disable the modem.For more information on modem configuration refer to the BCM50 Networking ConfigurationGuide (N0027156).To select the regionYou set the Region using Feature **PROFILE from a two-line display telephone.Refer to the BCM50 Telset Administration Guide (N0027176) for information on using TelsetAdministration to set this parameter.
