Chapter 4 LAN setup 57BCM50e Integrated Router Configuration - AdvancedUse the instructions in Table 8 to configure TCP/IP parameters for the LAN port.IP Alias SetupYou must use menu 3.2 to configure the first network. Move the cursor to the EditIP Alias field, press [SPACE BAR] to choose Yes and press [ENTER] toconfigure the second and third network.Press [ENTER] to open Menu 3.2.1 - IP Alias Setup, as shown in Figure 14.Table 8 LAN TCP/IP setup menu fieldsField Description ExampleTCP/IP Setup:IP Address Enter the IP address of your Business SecureRouter in dotted decimal notation.192.168.1.1(default)IP Subnet Mask Your Business Secure Router automaticallycalculates the subnet mask based on the IPaddress that you assign. Unless you areimplementing subnetting, use the subnet maskcomputed by the Business Secure Router.255.255.255.0RIP Direction Press [SPACE BAR] and then [ENTER] to selectthe RIP direction. Options are: Both, In Only,Out Only or None.Both(default)Version Press [SPACE BAR] and then [ENTER] to selectthe RIP version. Options are:RIP-1, RIP-2B or RIP-2M.RIP-1(default)Multicast IGMP (Internet Group Multicast Protocol) is anetwork-layer protocol used to establishmembership in a Multicast group. The BusinessSecure Router supports both IGMP version 1(IGMP-v1) and version 2 (IGMP-v2). Press[SPACE BAR] and then [ENTER] to enable IPMulticasting or select None (default) to disable it.NoneEdit IP Alias The Business Secure Router supports threelogical LAN interfaces via its single physicalEthernet interface with the Business SecureRouter itself as the gateway for each LANnetwork. Press [SPACE BAR] to select Yes andthen press [ENTER] to display menu 3.2.1.Yes
