Using the BayStack 660 Wireless LAN Access Point5-18 203939-BAssigning a Dynamic IP AddressThe AP Manager assigns an IP address to the access point each time the accesspoint starts up or reboots, using the entries in the BOOTP table. If you want topermanently assign an IP address, go to “Adding a New IP Address” on page 4-3.To dynamically assign an IP address:1. Choose Tools > BOOTP Table.The BOOTP dialog box (Figure 5-9) opens.2. Click the Assign Dynamic IP Addresses check box.3. Click OK.The IP addresses will now be assigned dynamically.Viewing the AP Manager VersionYou can check the version of software currently running on an access point.To check the version:• Choose > About.The About window opens and displays the AP Manager version number.Note: If you have a DHCP server, the access point obtains an IP address fromthis server. You can then use the AP manager to change the address if needed. If aDHCP server is available on the network, the access point receives its IP addressdirectly from it. Manual intervention is not necessary.book.fm Page 18 Wednesday, September 22, 1999 1:41 PM
