Installing and Starting the AP Manager203939-B 4-35Setting the Channel (DS)This sets the Channel (DS) for the access point. “DS” refers to Direct Sequence.To enable the Channel (DS):1. Choose Configure > Group.2. Select the group you want to configure.The Multiple Configuration Wizard dialog box (Figure 4-15) opens.3. Click Channel (DS).4. Click Next.The Channel (DS) dialog box opens.5. Enter a value between 1 and 11.6. Click Next.A confirmation dialog box opens.7. Click Finish if the information is correct.The Configuration Completion dialog box opens (Figure 4-16) showing thatthe changes are being processed.8. Click OK when the process is complete.Setting the Translation ModeTo set the Translation Mode for the access point:1. Choose Configure > Group.2. Select the group you want to configure.3. Click Translation Mode.4. Click Next.The Translation Mode dialog box opens asking you to select either:• 802.1h+NTISTT (default)• Straight encapsulation5. Select the translation mode.book.fm Page 35 Wednesday, September 22, 1999 1:41 PM
