Using the BayStack 660 Wireless LAN Access Point4-4 203939-BTo set the IP address using the BOOTP Request dialog box:1. Enter the following information:• IP Address• Subnet Mask• Gateway2. Choose whether the settings will Permanent or Dynamic.• If you click Permanent, the access point assigns the configurationpermanently in flash memory and retains the configuration even ifrebooted.• If you click Dynamic, the values added are entered in the BOOTP table.3. Click OK.Using Help to Set the IP AddressYou can also use Help set the IP address. To set the IP Address using Help:1. In the BOOTP Request dialog box (Figure 4-2), click Help.The IP Configuration Help dialog box opens.2. In the IP Address entry field, enter the last digits of the IP address.3. Choose Permanent or Dynamic.4. Click OK.Note: If you do not know the address for the three fields, contact your systemadministrator. It is important that you enter the information correctly.Note: If you select Permanent and the BOOTP Request dialog box (Figure 4-2)opens again, change the setting to Dynamic.Note: If you select Permanent and your system again requests an IP addressafter you reboot, choose Dynamic (and vice versa).book.fm Page 4 Wednesday, September 22, 1999 1:41 PM
