Using the BayStack 660 Wireless LAN Access Point4-8 203939-BThere are three possible status symbols in the first column of the access pointdialog box. Table 4-2 describes these status symbols.2. Click your access point (select only one device).3. Click Configure.The AP Manager logs in to the access point and then opens the Configurationdialog box, with the Basic tab option selected (Figure 4-5).Configuration Tab OptionsThe following sections describe the tabs in for the Configuration dialog box. Usethe tabs to define operational parameters for an access point.Table 4-2. Access Point Dialog Box Status SymbolsSymbol Description- Access point is not recognized by the AP Manager application.* Access point has been verified by the AP Manager application.! AP Manager attempted to verify the access point, but the attempt failed.Note: The Configuration dialog box may also open if you:• Choose Configure > Quick List > (group name). Group has one access point.• Choose Configure > Group > (group name). Group has one access point.book.fm Page 8 Wednesday, September 22, 1999 1:41 PM
