Command Line Interface203939-B 6-21• sys name— sets Access Point name• sys show— displays system attributesThe syntax for the system commands is:sys essid <ess_id_name>sys ether-link-mode {10base_2 | 10base_t}sys gateway <gtw_ip_addr>sys ip-address <sys_ip_addr> <sys_net_mask>sys ip-on-wport {enable | disable}sys load-image <file_name> <tftpd_ip_addr>sys name <sys_name>sys showwhere:ess_id_name is the ESS ID for wireless LAN.gtw_ip_addr is the IP address of the gateway.sys_ip_addr is the IP address of the access point.sys_net_mask is the network mask for the access point.file_name is the access point firmware file name.tftpd_ip_addr is the IP address of the TFTP server.sys_name is the name for the access point.book.fm Page 21 Wednesday, September 22, 1999 1:41 PM
