Using the System Setup Utility logs 1013. Thereafter make the following changes:a) BOOT->BOOT SETTINGS CONFIGURATIONQUIET BOOT [DISABLED]b) BOOT->BOOT DEVICE PRIORITY1ST BOOT DEVICE [PS-DW-224E-C]2ND BOOT DEVICE [00, AIC-7901A: 0 FU]c) SERVERASSERT NMI ONPERR[DISABLED]ASSERT NMI ONSERR[DISABLED]POWER LINK [POWER ON]FRB-4 POLICY [RESET]4. Proceed to "Exit" and save these newly configured settingsas "SAVE CUSTOM DEFAULTS".5. Then within "Exit" proceed to "Save Changes and Exit".6. Reboot server and verify settings.******* END OF TEXT DISPLAY*******4 During the boot up sequence, press F2 to change your CMOSsettings. Make your changes according to the text that appears inthe previous step.—End—Using the System Setup Utility logsThe System Setup Utility (SSU) hardware event logs record all the hardwareevents that take place while the system boots up and functions. SSU eventlogs are hardware logs, while the system event logs described in "Viewingevent logs" (page 29) apply to the software application. You can view SSUlogs even when the system is not operational through the utilities on theCallPilot Image DVD.ATTENTIONThis tool is only intended for use by authorized Nortel support personnel.Nortel CallPilot600r Server Maintenance and DiagnosticsNN44200-703 01.04 Standard5.0 25 April 2007Copyright © 2007, Nortel Networks.
