Replacing the DVD-ROM/CDRW drive 896 At the rear of the DVD-ROM drive, press inward on the cableretention clip at the right side of the DVD-ROM power cable. Whileholding the retention clip in, pull the power cable from the drive.7 Loosen the blue captive screw at the left side of the DVD-ROM driveassembly.8 Slide the DVD-ROM drive assembly from the chassis.Note: There are no cables to disconnect.Figure 25Removing DVD-ROM drive assembly from chassis9 Press downward on the side of the bracket where the blue captivescrew is attached to release the DVD-ROM drive from the drivebracket.10 Remove the two small screws that attach the backplane to the driveand put them aside to install the new DVD-ROM.11 Remove the DVD-ROM drive from the carrier.12 Attach the backplane to the replacement drive, using the screwsremoved in step 9. For details, see A in Figure 25 "RemovingDVD-ROM drive assembly from chassis" (page 89).13 Install the new DVD-ROM drive in the carrier.a. Line up the pins on each side of the bracket (two on each side)with the holes in the drive and set the replacement DVD driveinto the drive bracket. Push gently on one side of the bracket topush the pins into place.Nortel CallPilot600r Server Maintenance and DiagnosticsNN44200-703 01.04 Standard5.0 25 April 2007Copyright © 2007, Nortel Networks.
