80 Chapter 7 Replacing basic chassis componentsReplacing the power supplyThe 600r has only one power supply. You must power down the serverto replace the power supply.ATTENTIONDo not remove the power supply while the system is running. Power down thesystem and unplug the power supply before removing the power supply. After youpower down the server, allow the power supply to cool for several minutes.To replace the power supplyStep ActionDANGERRisk of electric shockHigh current inside the chassis can cause severe injury.1 After you power down the server, allow the power supply to coolfor several minutes.2 Remove the server cover. For instructions, see "Removing andreplacing the server cover" (page 77).3 Remove the PCI riser assembly. For instructions, see "Replacing theMPB96 card" (page 86).4 Lift up the rear of the power supply until it clears the two half-circlestops at the rear of the power supply. See letters A and B in Figure20 "Removing the power supply" (page 81).5 While holding the rear of the power supply above the stops, pushback at the front of the power supply to disconnect it from the powerboard. See (C) in Figure 20 "Removing the power supply" (page 81).Nortel CallPilot600r Server Maintenance and DiagnosticsNN44200-703 01.04 Standard5.0 25 April 2007Copyright © 2007, Nortel Networks.
