Installation of Network Wide Backup & Restore 2-3Network Wide Backup & Restore User Guide 450-3101-031 Rel 1.0 Standard June 19992Procedure 2-1 (continued)Installing the Network Wide Backup & Restore optional applicationStep Action10 A startup message prompts you if you want to proceed.If you wish to proceed, enteryes ↵11 A message prompts you for the name of the directory in which to store INMBackup & Restore.Note: Do not install the software in a directory called /tmp.If you use the default directory /opt/nortel, enterReturn ↵If you use another directory (this directory must already exist), enter ↵A directory called /inmbr will be created under the directory specified in thisstep (for example, the default directory will be /opt/nortel/inmbr). If youoverride the default with a directory called /my/directory/, the Backup &Restore software will be installed under /my/directory/inmbr.Meanwhile, a link /opt/nortel/inmbr will be created to point to/my/directory/inmbr.Note: The installation script checks the disk space in the specified filesystem. If there is not enough space, you will be prompted to type in anotherdirectory name.12 If a version of Backup & Restore has already been installed, a messageprompts you to confirm whether or not you want to re-use its run-timeconfiguration in the new installation.Note: Run-time configuration includes the information of all controllers thathave been added in the current Backup & Restore GUI, their backupschedules, the location of all backups, etc.If you wish to re-use the current run-time configuration, enteryes ↵Note: The installation will first back up the current run-time configuration intoa file called /tmp/inmbr_config.tar, and then restore it back after thenew load is installed.The configuration saved in this file can also be re-used by any later loadinstallation.13 If you don’t want to re-use the current run-time configuration, enterno ↵—continued—
