3-30 Administration of Network Wide Backup & RestoreIntegrated Network Management 450-3101-031 Rel 1.0 Standard June 1999Procedure 3-11Canceling an active controllerUse this procedure to cancel an active controller.RequirementsBefore you start, you must• be at the Network Wide Backup & Restore window• select the Controller Status tab (refer to Figure 3-9, The Controller Statustab on page 3-29)• have admin privilegesActionStep Action1 Click on the Cancel button.Note: Certain stages of a Backup or a Restore cannot be cancelled. ACancel command will fail if selected during one of these stages.—end—
