Nortel M3820 Installation And Administration Manual

Also see for M3310: Manual

Contents

70 Digital Telephone IP Adapter Installation and Administration GuideInstalling the Digital Telephone IP Adapter unit Standard 2.1Installing the Digital Telephone Internal IPAdapter circuit cardBefore you can install the Digital Telephone Internal IP Adapter circuit card,you must first remove the footstand of the digital telephone. For moreinformation about supported telephone footstands, refer to ìRequired footstandfor Digital Telephone Internal IP Adapter unitsî on page 46.Note: You can only add the Digital Telephone Internal IP Adapter circuit card todigital telephones that have an ATA/MCA footstand. To obtain an ATA/MCAfootstand, contact your Nortel distributor.Removing the footstand of the digital telephone setTo remove the footstand of the digital telephone set:1 Disconnect the telephone-side connection of the RJ-11 TCM telephonecable. The other end of this cable connects to the wall jack.2 Place the telephone on a flat surface with the keypad facing downward.Note: Ensure that you are grounded with an approved ESD strap.