Mediant 2000 SIPMediant 2000 SIP User’s Manual 250 Document #: LTRT-72504ini File Field Name Valid Range and Description IVR ReferenceNumberMapIP2Tel Manipulate the destination number for IP to Tel calls.NumberMapIP2Tel = a,b,c,d,e,f,g,h,ia = Destination number prefixb = Number of stripped digits from the left, or (ifbrackets are used) from the right. A combination of bothoptions is allowed.c = String to add as prefix, or (if brackets are used)as suffix. A combination of both options is allowed.d = Number of remaining digits from the righte = Q.931 Number Planf = Q.931 Number Typeg = Source number prefixh = Not applicable, set to $$i = Source IP addressThe ‘b’ to ‘f’ manipulation rules are applied if the calledand calling numbers match the ‘a’, ‘g’ and ‘i’ conditions.The manipulation rules are executed in the followingorder: ‘b’, ‘d’ and ‘c’.Parameters can be skipped by using the sign "$$", forexample:NumberMapIP2Tel =2222,4,http://10.3.0.2/AAIP.txtNote: The Source IP address can include the “x” wildcardto represent single digits. For example: 10.8.8.xxrepresents all the addresses between 10.8.8.10 to10.8.8.99.Replaces the incomingdestination number with a URLthat indicates where the VXMLscript is located.a = Calling Card numberb = The length of the CallingCard numberc = http:// + /+ (maximum length of string is 50characters)Note: To update the VoiceXMLfile, change the name of the filein the ‘c’ field.VoicePromptsFileNameThe name (and path) of the file containing the VoicePrompts definitions.SaveConfiguration Set to 1 to store the Voice Prompts file in the non-volatilememory (file size mustn’t exceed 1Mb).EnableVoiceStreaming 0 = Disable voice streaming (default).1 = Enable voice streaming.Set to 1 to enable the load ofthe VoiceXML file from theHTTP server.Table K-2: VoiceXML Related Parametersini File Field Name Valid Range and DescriptionEnableVxml[Enable VXML]0 = Disable the VXML feature (default).1 = Enable the VXML feature.VxmlID[VXML ID]According to this string, the Mediant 2000 recognizes that an incoming call is to be divertedto the IVR system.Note: Set to “http” (the “http” string must also appear in the manipulation table).VxmlCollectDigits Determines the destination to which the VXML script reports the collected number(username).0 = The collected number (username) is sent for authentication to the RADIUS server(default).1 = The collected number is sent (in INFO message) to an Application / Proxy server.The following RADIUS related parameters are described in Table 6-1 on page 90:• EnableRADIUS• MaxRADIUSSessions• SharedSecret• RADIUSRetransmission• RADIUSTo
