Mediant 2000 SIPMediant 2000 SIP User’s Manual 278 Document #: LTRT-72504Industry Canada NoticeThis equipment meets the applicable Industry Canada Terminal Equipment technical specifications. This is confirmed by theregistration numbers. The abbreviation, IC, before the registration number signifies that registration was performed based on adeclaration of conformity indicating that Industry Canada technical specifications were met. It does not imply that IndustryCanada approved the equipment.Digital Device WarningsThis equipment complies with Part 68 of the FCC rules and the requirements adopted by ACTA. On the bottom of thisequipment is a label that contains a product identifier in the format US:AC1ISNANMED2KDC. If requested this number must beprovided to the telephone company.The Telephone company may make changes in the facilities, equipment, operations or procedures that could affect theoperation of the equipment. If this happens the telephone company will provide advance notice in order for you to makenecessary modifications to maintain uninterrupted service. Should you experience trouble with this telephone equipment,contact: AudioCodes Inc, San Jose, CA USA. Tel: 1 408 577 0488. Do not attempt to repair this equipment!Do not attempt to repair this equipment!Facility Interface Code: 04DU9.BN, 04DU9.DN, 04DU9.1KN, 4DU9.ISNService Order Code: 6.0NUSOC Jack Type: RJ21X or RJ48CIt this gateway causes harm to the telephone network, the telephone company will notify you in advance that temporarydiscontinuance of service may be required. But if advance notice isn’t practical, the telephone company will notify the customeras soon as possible. Also you will be advised of your right to file complaint with the FCC if you believe it is necessary.Network Information and Intent of UseThe products are for access to ISDN at 2048 kb/s and for access to G.703 Leased lines at 2048 kb/s.Network CompatibilityThe products support the Telecom networks in EU that comply with TBR4 and TBR13.Telecommunication SafetyThe safety status of each port is declared and detailed in the table below:Ports Safety StatusE1 or T1 TNV-1Ethernet (100 Base-TX) SELVTNV-1: Telecommunication network voltage circuits whose normal operating voltages do not exceed the limits for SELVunder normal operating conditions and on which over voltages from telecommunication networks are possible.SELV: Safety extra low voltage circuit.FCC StatementThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCCRules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However there is no guarantee that interference will notoccur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can bedetermined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of thefollowing measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.
