Nortel SR1001 Installation Manual

Contents

Nortel SR1001 Installation Manual Manual pdf 33 page image

21SR1001 Installation GuideVersion 8.3.5Rack-Mount InstallationTo mount the SR1001 in an equipment rack, follow this procedure.Figure 14 Rack Mounting the SR10011 Determine the mounting position for the rack tray in the equipment rack (front or midmount) and attach the mounting brackets using the four (provided) 6-32 x .250 inch flathead Phillips screws.2 Attach the router to the carriage assembly using four (provided) Phillips pan head 4-40 x.250 inch screws.3 Engage the carriage assembly in the rack tray rails and slide the assembly all the way in.4 Fit the AC strap over the power supply and then place the power supply on the rack traybetween the raised tab and the back edge of the tray.5 Engage and tighten the AC strap captive screw to secure the power supply to the racktray.6 Attach the cable retainer bracket to the appropriately-rated DC power cord behind themolded strain relief on the cable.7 Insert the power cable jack into the 12 VDC port on the back of the router.8 Engage and tighten the captive screw on the cable retainer bracket in the threaded holeadjacent to the DC input jack on the router.9 Coil the excess cable and secure it on the tray behind the router.10 Mount the tray in the equipment rack using either four (provided) Phillips pan head 10-24x .5 inch screws or four (provided) Phillips pan head 12-32 x .5 inch screws, whichever fitsthe equipment rack.11 Connect the network cables to the router. Secure the cables in the clips located on thebottom of the carriage assembly. Refer to Network Connections on page 22.12 Connect the appropriate ends of the AC cord to the secured power supply and a 110/120VAC outlet.13 Using a small flat blade screwdriver, engage and tighten the captive screw to secure thecarriage assembly to the rack tray.Mounting Bracket Thumbscrew EngagementPower SupplyVelcroMountingPadsEngaged ThumbscrewRack Carriage Rack Tray