Nortel SR1001 Installation Manual

Contents

Nortel SR1001 Installation Manual Manual pdf 36 page image

24 CHAPTER 3Installation Operator InterfaceSR1001 Installation GuideVersion 8.3.5Operator InterfaceLocal Management The SR1001 can be locally configured, operated, and managed using an operator consoleconnected to the Console port. A terminal (VT-100 or equivalent) or workstation with terminalemulation software can be used for the operator console. Connect the console to the SR1001Console port using an RJ-45 cable with switched ends. If your terminal equipment requires aspecial cable, see Table 24 on page 58 for connector pinout information.To connect the Console cable:1 Connect the RJ-45 Console cable to the Console port on the router.2 Connect the other end of the RJ-45 Console cable to the RJ-45 end of the adapter.3 Connect the DB-9 end on the adapter to the management terminal or workstation.Figure 17 Connecting the Console Cable (Local Management)Remote Management A modem can be connected to the Console port and used to configure, operate, and managethe SR1001 remotely.Figure 18 Connecting a Modem for Remote Management%$&.83RJ-45 to DB-9 AdapterConsole Port%$&.83Console PortModemDB-25 Modem Adapter