Nortel SR1001 Installation Manual

Contents

Nortel SR1001 Installation Manual Manual pdf 78 page image

66 APPENDIX BCompliance and Standards FCC ConformanceSR1001 Installation GuideVersion 8.3.5FCC Conformance This section provides information about Nortel product conformance with FCC rules.FCC Part 15 Nortel products comply with FCC Part 15 (also known as CFR42, Chapter 2, Part 15) of theFederal Communications Commission (FCC) rules concerning radio frequency emissions forClass A computing devices. The following section is required by the FCC.CAUTION: In accordance with FCC Part 15, Section 15.21, changes or modifications made by the buyerthat are not expressly approved by Nortel, could void the buyer’s authority to operate this equipment.This equipment has been tested and found to comply with the limits for a Class A digitaldevice, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonableprotection against harmful interference when the equipment is operated in a commercialenvironment. This equipment generates, uses, and can radiate radio frequency energy and, ifnot installed and used in accordance with the instruction manual, may cause harmfulinterference to radio communications. Operation of this equipment in a residential area islikely to cause harmful interference, in which case the user will be required to correct theinterference at his own expense.You can determine whether your equipment is causing interference by turning it off. If theinterference stops, it was probably caused by the Nortel equipment. If the equipment causesinterference to radio or television reception, try to correct the interference by using one ormore of the following measures: Turn the television or radio antenna until the interference stops Move the equipment to one side or the other of the television or radio Move the equipment farther away from the television or radioFCC Part 68 This equipment complies with Part 68 of the FCC rules. The FCC Part 68 label is located on thebottom chassis panel. This label contains the FCC Registration Number and Ringer EquivalenceNumber (REN) for this equipment. If requested, this information must be provided to yourtelephone company.Connection to the telephone network should be made by using standard modular telephonejacks, type RJ-48C. The RJ-48C plug and/or jacks used must comply with the FCC Part 68rules.Incidence of Harm If your telephone equipment causes harm to the telephone network, the telephone companywill notify you in advance that temporary discontinuance of service may be required. But ifadvance notice is not practical, the telephone company will notify you as soon as possible.Also, you will be advised of your right to file a complaint with the FCC if you believe it isnecessary.MFRs PortIdentifierFacilitiesInterfaceCodeServiceOrderCodeNetworkConnectorsWAN Ports 1 04DU9-1SN04DU9-1ZN6.0N RJ-48C