Nortel SR1001 Installation Manual

Contents

Nortel SR1001 Installation Manual Manual pdf 39 page image

SR1001 Installation GuideVersion 8.3.5274CONFIGURATIONThis chapter describes how to login, change the default password, configure the router andusers, and change the factory default configuration. The boot process and software upgradeprocess is also discussed in detail.Logging InIf you have not established a local console connection, see Operator Interface on page 24 formore information.The following figure shows the login sequence and the initial prompt after login is complete.Figure 19 Initial CLI PromptNOTE: The default host name is Nortel.Command Tips Use the following command tips and shortcuts with command line interface commands. To display all commands, type tree. To access help associated with a command, type help <command name>. You may also usethe ? key after any command. To exit back one level in the command hierarchy, type exit and press Return. To exit the command mode and/or return to the base CLI prompt, press the keycombination Ctrl-Z. Type the first two letters of a command, and then press the Tab key to automatically spellout the command. Scroll through the available commands using the Tab key.Ethernet Configuration TipTo avoid Ethernet mismatch problems, the SR1001 and the network device to which it isattached should both be configured identically for speed and duplex. For example, if therouter is configured for auto-negotiation and the far end is configured manually, the routerInitial CLI Promptlogin: usernamepassword:username logged in on Fri August 6 05:28:01 2004from console