Notifier AM2020 User Manual

Also see for AFP1010: Manual User guide Operator instructions Operation and installation manual

Contents

Notifier AM2020 User Manual Manual pdf 243 page image

4-29Security 15088:K 03/21/01- +Listed 24 VDCPower Supply.SLC Loop +24 VDC listedSecurity Notification Appliance47KEnd-of-Line Resistor(A2143-00)NOTEThe CMX may also control audiospeakers in an audio application. Insuch an installation, fire alarmconditions must have priority oversecurity conditions in the AMG-1 (referto the Voice Alarm Multiplex Manual).CMX-1 or CMX-2(activated polarity shown)Configured as a Notification ApplianceCircuit (do not break tabs) and pro-grammed in the Protected Premises Unit.Refer to Figure 1.3-16 for the wiring of security notification appliances (supplementary use only in UL listedsystems). See Table 1.1-1 in the introduction to this section for monitor and control module options.CMX-1orCMX-2Figure 1.3-16 System RequirementsTENANT AMM CM*KeyMotion DetectorContact SwitchContact Switch w/MMMM Security Area MonitorAM2020/AFP1010Central StationRKS-S Remote Keyswitch w/MMPull StationSmoke DetectorGroup InterfaceACM-16AT or ACM-32A Remote Annunciator*MM CMNotification Appliance w/CMArea8.cdr* Group Interface must bephysically located in either theprotected premises or theCentral StationSLC