OHAUS Ranger 7000 R71MHD3 Instruction Manual

Also see for ranger 7000: Instruction manual Quick start guide Instruction manual Instruction manual Instruction manual

Contents

OHAUS Ranger 7000 R71MHD3 Instruction Manual Manual pdf 51 page image

RANGER®7000 SCALES EN-495.9.5 HandshakeSet the flow control method.NONE = no handshakingXON/XOFF = XON/XOFF handshakingHARDWARE = hardware handshaking (COM1 menu only)5.9.6 Alternate CommandEnter this sub-menu to set a different command character for the P (Print), T(Tare) orZ(Zero)Alternate Print CommandSet the alternate command character for Print.Settings of A(a) to Z(z) are available, except T&Z. The default setting is P.Alternate Tare CommandSet the alternate command character for Tare.Settings of A(a) to Z(z) are available, except P&Z. The default setting is T.Alternate Zero CommandSet the alternate command character for Zero.Settings of A(a) to Z(z) are available, except P&T. The default setting is Z.Print Setup Menu: (RS232 shown)5.9.7 ResetResets the settings to factory default settings. Reset the settings to factory defaultsettings.5.9.8 Stable Weight OnlySet the printing criteria.OFF = values are printed immediately, regardless of stability.ON = values are printed only when the stability criteria are met.5.9.9 Auto PrintSet the automatic printing functionalityOFF = disabledON STABLE = printing occurs each time the stability criteria are met.INTERVAL = printing occurs at the defined time interval.CONTINUOUS = printing occurs continuously.When ON STABLE is selected, set the time interval using the numeric keypad.LOAD = prints when the displayed load is stableLOAD ZERO = prints when the displayed load or zero reading is stable.When INTERVAL is selected, set the time interval using the numeric keypad.Settings of 1 to 3600 seconds are available.Note: Pressing the print button when INTERVAL has been selected will print the displayed resultimmediately.