13 Utility mode13-42 CS250/CS240/CS23113.7 Printer adjustmentLeading edge adjustmentThe starting print position at the leading edge of each type of paper (with respect to the paper feed direction)can be adjusted.0 The starting print position is adjusted during manufacturing of the machine. Normally, the starting printposition will not need to be adjusted.1 Display the Administrator Settings screen.– For details on displaying the Administrator Settings screen, refer to "Displaying the administratorsettings screen" on page 13-37.2 Touch [1 System Settings].The System Settings screen appears.3 Touch [7 Expert Adjustment].The Expert Adjustment screen appears.4 Touch [2 Printer Adjustment].The Printer Adjustment screen appears.5 Touch [1 Leading Edge Adjustment].The Leading Edge Adjustment screen appears.6 Touch the button for the paper type to be set.7 Press the [Start] key.– Only paper loaded into the bypass tray can be used.A test pattern is printed.8 Check that the distance from the starting print position of the test pattern to the edge of the paper (a)is 4.2 mm.– If the distance is less than 4.2 mm, touch [+] to increase the adjustment (between 0.2 mm and 3.0mm).– If the distance is more than 4.2 mm, touch [-] to reduce the adjustment (between -0.2 mm and -3.0mm).– Each time [+] or [-] is touched, the value is increased or decreased by one increment.9 Press the [Start] key.The adjusted test pattern is printed.
