CS250/CS240/CS231 3-35Before making copies 3Automatically clearing settings (automatic panel reset)If no operation is performed for a specified length of time (even if the [Reset] key is not pressed), settings thathave not been programmed, such as the number of copies, are cleared and return to their default settings.This is the automatic panel reset operation.As the factory default, the automatic panel reset operation is performed after 1 minute.!DetailThe length of time until the automatic panel reset operation is performed and whether or not it isperformed can be set from Utility mode. For details, refer to "System settings" on page 13-23.Whether or not the automatic panel reset operation is performed when there is a change of user can beset from the Utility mode. For details, refer to "System settings" on page 13-23.Automatically canceling the mode screen (system auto reset)If no operation is performed for a specified length of time, the screen is automatically changed to that for themode given priority.This is the System Auto Reset operation.As the factory default, the Copy mode screen is displayed after 1 minute.!DetailThe mode screen that is displayed when the System Auto Reset operation is performed can be changedfrom the Utility mode. For details, refer to "System settings" on page 13-23.Automatically conserving energy (low power mode)If no operation is performed for a specified length of time, the touch panel goes off and the machineautomatically enters a mode where it conserves energy.This is the Low Power mode.The machine can receive jobs even while it is in Low Power mode.As the factory default, the machine enters Low Power mode after 15 minutes.To recover from Low Power mode1 Press the [Power Save] key.2 The machine can receive jobs while it is warming up.– The touch panel comes on again and, after the machine has finished warming up, it is ready to beginprinting.2 NoteAs the factory default, pressing the [Power Save] key causes the machine to enter Low Power mode.Settings in the Administrator Settings mode can be changed to put the machine in Sleep mode instead.For details, refer to "System settings" on page 13-23.The Low Power mode can also be canceled by pressing any key in the control panel or by touching thetouch panel.
