VL3622c/VL2822c/VL2222c 9-59.2 Troubleshooting table 99.2 Troubleshooting tableSimple troubleshootingThe following explains simple troubleshooting procedures. If the problem is not corrected after the describedoperation is performed, contact your service representative.Description of problem Check points RemedyThe machine does not start upwhen the Main Power Switch isturned onIs power being supplied from theelectrical outlet?Correctly insert the power supplyplug into the electrical outlet.Has the Sub Power Switch beenturned on?Turn on the Sub Power Switch.Copying does not start Is the Top Right Door of the ma-chine open?Securely close the Top RightDoor of the machine.Is there any paper that matchesthe original?Load paper of the appropriatesize into the paper tray.The printed output is too light Is the copy density set to [Light]? Press [Dark] in the Densityscreen to copy at the desiredcopy density. (p. 5-19)Is the paper damp? Replace with new paper. (p. 8-4)The printed output is too dark Is the copy density set to [Dark]? Press [Light] in the Densityscreen to copy at the desiredcopy density. (p. 5-19)Was the original not pressedclose enough against the Origi-nal Glass?Position the original so that it ispressed closely against theOriginal Glass. (p. 3-6)The image is partially obscuredor blurry.Is the paper damp? Replace with new paper. (p. 8-4)Was the original not pressedclose enough against the Origi-nal Glass?Position the original so that it ispressed closely against theOriginal Glass. (p. 3-6)There are dark specks or spotsthroughout the printed outputThere are streaks in the printedoutputIs the Original Glass dirty? Wipe the Original Glass with asoft, dry cloth. (p. 8-11)Is the Slit Scan Glass dirty? Clean the Slit Scan Glass withthe original glass cleaner.(p. 8-11)Is the Original Pad dirty? Clean the Original Pad with asoft cloth dampened with a milddetergent. (p. 8-12)Was the original printed on highlytranslucent material, such as dia-zo photosensitive paper or OHPtransparencies?Place a blank sheet of paper ontop of the original. (p. 3-6)Is a 2-sided original being cop-ied?If a thin 2-sided original is beingcopied, the print on the back sidemay be reproduced on the frontside of the copy. In the Back-ground Removal screen, select alighter background density.(p. 5-19)Is the Electrostatic ChargerWire dirty?Use the Charger Cleaner toclean the Electrostatic ChargerWire. (p. 9-12)
