VL3622c/VL2822c/VL2222c 11-311.1 Using authentication unit (IC card type) 1111 Authentication unit (IC card type)This chapter describes the Authentication Unit (IC card type) AU-201.1. Authentication Unit (IC card type) AU-20111.1 Using authentication unit (IC card type)The Authentication Unit (IC card type) AU-201 is an "IC card authentication" system that reads the IC cardto perform personal authentication. Using this system, you can perform authentication with an IC card to login to this machine or execute a print job when User Authentication is enabled in this machine.To use the authentication unit, first register the card ID of the user in this machine. The registered user, whois authenticated with the card ID, can log in to this machine or execute a print job. This section explains howto configure the required settings in this machine, register users, and log in with authentication.For details on how to place the IC card in the authentication unit, refer to the [Quick GuideCopy/Print/Fax/Scan/Box Operations].NOTICEAuthentication Unit (IC card type) AU-201 must be installed inside the Working Table WT-507 or WorkingTable WT-506.Do not disconnect the USB cable while using the authentication unit. Doing so may cause the system to be-come unstable.Do not leave the IC card within 1-9/16 inch (40 mm) of the card reader.11.1.1 Configuring this machineNOTICEAuthentication Unit (IC card type) AU-201 must be installed inside the Working Table WT-507 or WorkingTable WT-506.User authentication settings must be configured with MFP authentication on this machine.This device does not support external server authentication. For [Public User Access] or [Account Track] set-tings, refer to page 7-27. To combine account track settings with user authentication settings, set Synchro-nize User Authentication & Account Track to [Synchronize].1 Use the Control Panel of this machine to display the Administrator Settings screen. Press [User Au-thentication/Account Track], then [General Settings].1