Oce cm4010 Facsimile Manual

Also see for cm2510: User guide System settings guide Troubleshooting guide Safety guide Programming Date & Time

Contents

Oce cm4010 Facsimile Manual Manual pdf 60 page image

59INFORMATION APPEARING IN THE RESULT COLUMNError types and other information are printed in the result column of the report. Check the transaction result in the resultcolumn and take appropriate action if the result is an error.Examples of messages that are printed in the result columnMessage ExplanationOK The transaction was completed normally.G3 Communication took place in G3 mode.ECM Communication took place in G3 ECM mode.SG3 Communication took place in Super G3 mode.FW. The received data was forwarded.NO RESPONSE No response from the receiving party.BUSY Transmission was not possible because the other party was already using the line.CANCEL The transmission was cancelled while in progress.MEMORY OVER The memory became full during quick on-line transmission.MEM.FULL The memory became full during reception.LENGTH OVER The transmitted fax was over 1.5 m (59") long and therefore could not be received.ORIGINAL ERROR Direct transmission or manual transmission was not successful because a misfeed occurred.PASS# NG The connection was broken because the polling passcode was not correct.NO RX POLL The machine that was polled does not have a polling function.RX POLL FAIL The other machine refused the polling operation, or your machine broke the connection whenpolled because no data was in memory.NO F-CODE POLL The other machine refused an F-code polling operation, or your machine broke the connectionwhen polled because no data was in its F-code memory polling box.RX POLL# NG The connection was broken because the sub-address for F-code polling memory was not valid.F POLL PASS# NG The connection was broken because the passcode for F-code polling memory was not valid.BOX NO. NG Your machine broke the connection because the specified sub-address for an F-code memorybox does not exist.F PASS# NG Your machine broke the connection because the other machine sent an incorrect passcode forF-code communication.RX NO F-CODE POLL F-code polling was attempted, however, the other machine did not have an F-code pollingmemory box.NO F FUNC F-code communication was attempted, however, the other machine does not support F-codecommunication.NO F-CODE F-code communication was refused by the other machine because of an incorrect sub-address orother reason.M. BOX: [xxxxxx] Data was received to a confidential or relay broadcast memory box, or data was sent from amemory polling box.The name of the memory box appears in [xxxxxx], and the type of F-code operation (relay requestreception, polling memory transmission, or confidential reception) appears in .NG xx (xxxx) The communication handshake signals or image signals were distorted due to line conditions orother reasons, and communication was not successful.(1) First two digits of communication error number: Error code from 00 to 99.(2) Last four digits of communication error number: Code for use by service technicians.REJECTED A fax was sent from a party from which reception is blocked.(1) (2)