Commands 6-23Octel Overture 200/300 Serenade 3.0PB60014–01If the LIST NET command is followed by digits from the uniform numbering plan of a domain, themessages pending for all domain network locations are listed. For example, the command LIST NET 4,where the digit 4 is the first digit in the uniform numbering plan, gives exactly the same listing as LISTNET DOMAIN in the preceding example.You can list information about a specific domain location, rather than all domain locations, by adding thelocation name after the D in the LIST NET D command, as follows:@L NET D DALLASLOCATION FRAME NUMBER: 0004DELAY: 00002 MIN.ERRORS: 00000LIMIT: 00001MESSAGE #2001LAN StatusUse the LANSTAT command to provide basic information about the current status of the LAN card,digital networking and the Gateway Link. Information about the status of the LAN for previous periods inthe Network Traffic Report for Digital Networks and the Digital Network Performance Report. Forinformation about those reports, refer to the Reports chapter, Network Reports section, in this volume.Use the LANSTAT command for information about the current status, whether the LAN is UP or DOWNand the state of the high-speed links.The following example shows that the LAN is up and running:@LANSTATLAN STATUS: UPLAST INITIALIZED ON 05/25/97 AT 06:05 PMDIGITAL NETWORKING STATUS: UP–––––––– HIGH–SPEED–LINK STATUS ––––––––––––––––LOCATION STATUS LAN–PRTCL OTHER––––––––––––––––––––––––––––––––––––––––––––––––SELF – 3CHCGO UP 2NEWYRK DOWN –DALLAS DOWN 1 OEM–FAILSFO UP 3––––––––––––––––––––––––––––––––––––––––––––––––GWL STATUS: DOWN – GATEWAY LINK SYSTEM PARAMETER IS NOT ENABLED@The entry in the LAN STATUS field is always UP, INITIALIZING, or DOWN.The LAN card is running, with CPU communication to the card. The LAN isrunning normally. If a Courtesy Down is in progress, the message COURTESYDOWN IN PROGRESS is shown.When the LAN status is UP, the high-speed link status is given for each high-speeddigital location, as follows:LAN Status
