6-28Installation and Maintenance VolumeOctel Overture 200/300 Serenade 3.0 PB60014–01Port Mapping StatusUse the PRTMAP command to display information about the assignment of message-server port numbersto ports configured in each slot. This command also displays the assignment of each port to an integrationunit. At the @ prompt, typePRTMAP If the PBX type is ATT75, each port can be assigned to more than one integration unit. If the PBX type isnot ATT75, each port can be assigned to only one integration unit and is assigned a line-appearancenumber for that integration unit.If a port is assigned to an integration unit and that port has the COS attribute for nonintegration, Attribute58 — DO NOT USE THIS PORT FOR INTEGRATION, this command prints *** after the integrationinformation for the port. The discrepancy in the configuration must be resolved, either by removing theCOS attribute from the port or removing the port from all integration units.The following is an example of the PRTMAP command without ATT75 assigned:@PRTMAPSYSTEM INTEGRATION LINEPORT SLOT PORT EXTN SLOT/UNIT APPEARANCEID= 01 1 1 1210 10/1 12 1 2 1211 10/1 23 1 3 1212 10/1 34 1 4 1213 10/1 4ID= 05 2 1 125 10/1 5The following is an example of the PRTMAP command with ATT75 assigned:@PRTMAPSYSTEM INTEGRATIONPORT SLOT PORT EXTN SLOT/UNITID= 01 1 1 121 10/1 10/2 11/1 11/22 1 2 122 10/1 10/2 11/1 11/23 1 3 123 10/14 1 4 124 10/2ID= 05 2 1 125 10/2Floppy-Disk-Drive DiagnosticsUse the floppy-disk-drive (FD) diagnostic command TEST FLOPPY 1 to isolate faults to the diskette,floppy-disk drive, or floppy-disk controller. To run this test, at the @ prompt, typeTE F 1
