- 99 -Network Setting Items5 5. Network SettingsShaded text indicates the factory default setting.ItemSetting DescriptionTELNET WebbrowserConfigurationTool(NetworkSetting Plug-in)NetworkCard Setup(Windows)NetworkCardSetup(Mac)AuthenticateServerAuthenticateServer- - - ENABLE Set whether toauthenticate a certificatesent from the RADIUSserver by using a CAcertificate.DISABLEEAP retry - - - - 1 Set the number ofretries of IEEE802.1Xauthentication. Up to9 times can be set.Normally, use the factorydefault setting.-3-9EAPtimeout- - - - 10 Set the timeout to waitfor the response from theserver during IEEE802.1Xauthentication. Set thevalue within the rangeof 10 to 60 seconds.Normally, use the factorydefault setting.-60 IPSecShaded text indicates the factory default setting.ItemSetting DescriptionTELNET WebbrowserConfigurationTool(NetworkSetting Plug-in)NetworkCard Setup(Windows)NetworkCardSetup(Mac)IPSec IPSec - - - ENABLE Set whether to use IPSec.DISABLE- IP Address1-50- - - 0.0.0.0 Specify the host addressallowed to communicateby IPSec.● Use one-bytecharacters separatedby a dot for an IPv4address.● Use one-bytealphanumericcharacters separatedby a colon for an IPv6global address.● IPv6 link-local addressis not supported.- IKEEncryptionAlgorithm- - - 3DES-CBC Set the IKE encryptionmethod.DES-CBC- IKE HashAlgorithm- - - SHA-1 Set the IKE hash method.MD5- Diffie-HellmanGroup- - - Group1 Set the Diffie-Hellmangroup used in Phase1Proposal.Group2
