C – 10Menu Selections for Serial InterfacingChapter 1 explains how to use your printer’s Menu Select mode. If you are using theserial interface, set the following Menu Select options according to your computer’sinterface requirements.Printout ActionPARITY Does your system use ODD or EVEN parity?ODD parity –select ODDEVEN parity –select EVENNONE – select NONESERIAL DATA Does your system use 7 or 8-bit format?7/8 BITS 7-bit format – select 78-bit format – select 8PROTOCOL What protocol does your system use?Ready-Busy protocol – select READY/BUSYXON/XOFF protocol – select XON/XOFFDIAGNOSTIC TEST Do you want to perform a diagnostic test?(See page D-5) Yes – select YESNormal operation – select NOBUSY LINE Which system will your system use to recognise a busysignal?SSD - 9V – select SSD -SSD +9V – select SSD +DTR - 9V – select DTRRTS - 9V – select RTSBAUD RATE What baud rate does your system use?19200 baud – select 19.29600 baud – select 9.64800 baud – select 4.82400 baud – select 2.41200 baud – select 1.2600 baud – select 0.6300 baud – select 0.3DSR SIGNAL How does your system handle the Data Signal Ready?Valid – select VALIDInvalid – select INVALID
