Oki Pro1040 Maintenance Manual

Also see for Pro1040: User guide Setup guide User guide

Contents

- 108 -Specifications Continuous paper (with black marks)W2DCL4L6BLBWBWBWBLBLBLL1L1L4L4L4L5L5L5L6L6 L6L5'L2AL2A AAL2B B BPaper feed directionPrinting rangeBlack markWinding direction Outside winding: Printable surface faces out.Inside winding: Printable surface faces inPaper weight 0.07 to 0.25 mm (0.003 to 0.0098 inches)Core Inner diameter: 76.2 mm (3 inches)Outer diameter 203.2 mm (8 inches) or lessOther W2 : Paper width 25.4 to 130 mm (1 to 5.12 inches)L1 : Black mark interval 15.9 to 1324.0 mm (0.626 to 52.126 inches)* The black marks contain carbon.L2 : Paper length 12.7 to 1320.8 mm (0.5 to 52 inches)L4 : Cut size when in cut mode 101.6 mm (4 inches) or moreHowever, if the length of one label is less than 101.6 mm(4 inches), then the shortest length is 101.6 mm(4 inches) as multiple sheets are cutL5 : Upper edge cutting margin 1.7 mm (0.067 inches)L5' : Position of leading edge ofpaper1.2 to 4.0 mm (0.0472 to 0.1575 inches)Length of leading margin when paper is loadedL6 : Lower edge cutting margin 1.5 mm (0.059 inches)BW : Black mark width More than 5 mm (0.197 inches) from edge of paper (*1);maximum is width of paper W2 from edge of paperBL : Black mark length 3 mm (0.12 inches)A : Top margin 2.12 mm (0.0835 inches)B : Bottom margin 3.2 mm (0.126 inches) * In practice, it is the length ofthe gapC : Left margin 2.12 mm (0.0835 inches) or moreD : Right margin 2.12 mm (0.0835 inches) or more(*1) If an accurate position to start printing on the leading edge is needed, use a black mark in the center of the paper's width.