Oki Pro1040 Maintenance Manual

Also see for Pro1040: User guide Setup guide User guide

Contents

- 109 -Specifications Die-cut label paperW1W2 W4W3L1L2L1L3L3 L2DCABABL4L6L6L5 L5L6L5L6L2AB BL3L4 L4L4AL5'Paper feed direction4R1 or greaterPrinting rangeLinerWinding direction Outside winding: Printable surface faces out.Inside winding: Printable surface faces inPaper weight 0.07 to 0.25 mm (0.003 to 0.0098 inches)Core Inner diameter: 76.2 mm (3 inches)Outer diameter 203.2 mm (8 inches) or lessOther W1 : Liner width 29.4 to 130 mm (1.1575 to 5.12 inches)W2 : Label width 25.4 to 126 mm (1 to 4.9606 inches)W3 : Right liner width 2 to 25.4 mm (0.0787 to 1 inch)W4 : Left liner width 2 to 25.4 mm (0.0787 to 1 inch)L1 : Label pitch 15.7 to 1330.8 mm (0.618 to 52.3937 inches)L2 : Label length 12.7 to 1320.8 mm (0.5 to 52 inches)L3 : Gap between labels 3 to 10 mm (0.12 to 0.3937 inches)L4 : Cut size when in cut mode101.6 mm (4 inches) or moreHowever, if the length of one label is less than 101.6 mm(4 inches), then the shortest length is 101.6 mm(4 inches) as multiple sheets are cutL5 : Upper edge cutting margin 1.7 mm (0.067 inches)L5' : Position of leading edge ofpaper1.2 to 6.5 mm (0.0472 to 0.2559 inches)Length of leading liner when paper is loadedL6 : Lower edge cutting margin 1.3 to 8.3 mm (0.051 to 0.3268 inches)A : Top margin 2.12 mm (0.0835 inches) or moreB : Bottom margin 2.12 mm (0.0835 inches) or moreC : Left margin 2.12 mm (0.0835 inches) or moreD : Right margin 2.12 mm (0.0835 inches) or more