- 29 -If Other Messages Are DisplayedMessage displayed on thedisplay screenErrorcodeATTENTIONlamp Causes and Troubleshooting ReferencepagesThe data will be deleted due to aspot color order mismatch error.Check the print cartridgeposition and spot color settings,and try to print again. To turnoff the display, press OK buttonPlease see HELP for details7380 Blinking The position of the white print cartridgeis different from that specified in theprinter driver.Printing has been stopped, and the datawas deleted.Check the order of the print cartridgeand the Spot Color setting, then printonce again.Press the button to delete thedisplay on the display screen.-Check Waste Toner BoxPlease see HELP for details331 Blinking The waste toner box is not set correctly.Install the waste toner box correctly.-Firmware Update ErrorPlease retryIf network doesn’t work, pleasetry firmware update over USB302 - Firmware update failed.Follow the instructions in the message.-Feeder Unit Not InstalledShut down and Install FeederUnit7305 Blinking The unwinder is not installed.Turn off the power, and then install theunwinder.-Belt Unit Not InstalledPlease see HELP for details689 Blinking The belt unit is not installed properly.Press the button, and solveaccording to the guidance shown on theHelp screen.-Check Belt UnitPlease see HELP for details330 Blinking The belt unit is not installed correctly.Install the belt unit correctly.-Unnecessary Print CartridgeErrorCheck the position of printcartridge lift up leverPlease see HELP for details73987399Blinking The lift up lever of the print cartridge isnot in the correct position.Press the button, and solveaccording to the guidance shown on theHelp screen.-Install Paper GuideRe-set the Paper GuidePlease see HELP for details7384 Blinking The paper guide is not set correctly.Press the button, and solveaccording to the guidance shown on theHelp screen.-Open CoverPaper was pulled out7312 Blinking Paper was forcefully extracted whilebeing fed.Open the cover and if there are scrapsof paper, remove them, and then closethe cover.-Check Installed Paper EdgePaper Edge Long ErrorPress OK ButtonPlease see HELP for details7308 Blinking The mark on the leading edge of thepaper cannot be detected correctly.Replace the paper, and then press the button.Press the button, and solveaccording to the guidance shown on theHelp screen.-Paper Width ErrorPress OK ButtonPlease see HELP for details7383 Blinking The paper currently being used isdifferent from the paper settings in theprinter driver.Replace the paper, and then press the button.Press the button, and solveaccording to the guidance shown on theHelp screen.-
