Preparation before Use2-52Loading OriginalsFollow the steps below to load originals for copying, sending or storing.Placing Originals on the PlatenYou may place books or magazines on the platen in addition to ordinary sheet originals.1 Open the original cover or the document processor.NOTE: Before opening the document processor, be surethat there are no originals left on the original table or on theoriginal eject table. Originals left on the original table or onthe original eject table may fall off when the documentprocessor is opened.Keep the document processor open if the original is 25 mmor thicker.2 Place the original. Put the scanning side facedown andalign it flush against the original size indicator plate withthe back left corner as the reference point.3 Close the the original cover or the document processor.IMPORTANT: Do not push the original cover forcefully whenyou close it. Excessive pressure may crack the platen glass.Do not close the document processor when the original is25 mm or thicker.NOTE: Shadows may be produced around the edges and inthe middle of open-faced originals.CAUTION: Do not leave the document processor open asthere is a danger of personal injury.
