Olympus SP-610UZ Instruction Manual

37ENSelecting the ISO sensitivity1 Select the ISO setting option in the functionmenu.PP0.00.0AUTOWBAUTOWB200ISO200ISO100ISOISO1001/400 F3.3F3.31/400400ISO400ISOISO 200ISO 200MENUMENU2 Use HI to select the setting option, andpress the A button to set.Option DescriptionISO AutoThe camera automatically adjuststhe sensitivity according to theshooting scene.High ISO AutoThe camera uses a higher sensitivitycompared to [ISO Auto] to minimizeblur caused by a moving subject orby camera shake.Value The ISO sensitivity is fi xed to theselected value.In the ISO setting, although smaller values result inless sensitivity, sharp images can be taken under fullylit conditions. Larger values result in higher sensitivity,and images can be taken at fast shutter speeds evenunder low light conditions. However, high sensitivityintroduces noise into the resulting picture, which maygive it a grainy appearance.Sequential shooting (Drive)Pictures are taken sequentially while the shutter buttonis held down.1 Select the drive option in the function menu.0.00.0AUTOWBAUTOWBAUTOISOAUTOISOPPSequentialSequential MENUMENU14 M44 NORMOption Descriptiono One frame is shot each time theshutter button is pressed.j*1Take sequential shots using thefocus, brightness (exposure) andwhite balance set in the first frame.c The camera takes sequential shotsat a faster speed than in [j].d The camera takes sequential shotsat approximately 10 frames/sec.*1 The shooting speed varies depending on the settingsfor [Image Size/Compression] (p. 39).When set to [j], the flash (p. 34) cannot be set to[Redeye]. In addition, when set to [c] or [d], theflash is fi xed to [Flash Off].When set to [c] or [d], [Image Size] is limited to[n] or lower (for [c]), or [3] or lower (for [d]),and the ISO sensitivity is fixed to [ISO Auto].When set to [j] , [Image Size] cannot be setto [6]. Also, when set to [j] and [ImageSize] is [4] or [K], [Fine] cannot be set for[Compression].