Omnia-6ex Use and Operation Manual – V: 1.2029User Interface Tutorial – Input Source Selection and PeakInput Level SettingThe following two exercises are a useful introduction to the user interface. Start from the Main Menu (as displayedwhen the unit is first turned on).The first exercise changes a parameter selection (the Input Source selection):1. Rotate the jog-wheel to highlight Input.2. Click the jog-wheel (push on the wheel once) to bring up the Input window (shown below).Input Source SelectHome Icon “H” Input MenuHeadphone Level Control3. Rotate the jog-wheel until one of the Input Source choices: Analog or AES/EBU is highlighted. The filled boxnext to the selection name identifies the current selection. The factory default selection for Input Source isAnalog. To change the selection to AES/EBU, highlight AES/EBU and click. The AES/EBU box will now befilled and the digital input is now active. If you are using the analog inputs, highlight Analog and click toreselect the Analog inputs.4. Rotate the jog-wheel until the Home icon “H” is highlighted in the lower left corner of the window. Click toreturn to the Main Menu.5. Note that as you adjust the Input Source selection in this menu, the wording above the Input level bargraph onthe Meter Screen changes to follow the selected source name.
