Omnia Omnia-6EX / EXi Installation And Operation Manual

Contents

Omnia Omnia-6EX / EXi Installation And Operation Manual Manual pdf 37 page image

Omnia-6ex Use and Operation Manual – V: 1.2037ProcessThis menu is a graphical block-diagram representationof the signal flow through the Omnia-6fm. Each block-diagram icon, when highlighted and clicked, opens upa parameter window that pertains to that part of theOmnia-6EX processing circuitry. See Chapter 5, “FineTuning Your Sound” starting on Page 61 for an in-depth discussion of using this menu to edit presets.Process MenuInputThis menu has six items:• Input Gain Master, Right Trim, Master Drive• Input Source Selection• Invert Both Channels Option• Input Mode Selection• HP Filter Selection• Phase Rotation SelectionInput MenuInput Gain Master / Right TrimThese controls set both the analog and digital input peak levels (simultaneously). For analog and digital signals, thecontrol range is from –12.0 to +12.0 dB of gain. The factory default control setting of 0.0dB corresponds to amaximum peak input level of +22dBu. To change the input sensitivity, highlight the Master (Not Master Drive)control and click, then use the jog-wheel to adjust the level in precise 0.1 dB steps. –12.0 dB has the least amount ofgain; +12.0 dB is the maximum gain. This control adjusts the gain of both the Left and Right channelssimultaneously. Compare the setting of this control with the input bargraph meters so that signal peaks (the“bouncing balls”) read between -12 and -6 dBFS. To correct any balance errors, use the Right Trim control. Thiscontrol adjusts only the gain of the Right Channel over a limited range of plus or minus 3 dB in precise 0.1 dB steps.