47 ShootingCharging the built-in battery/setting the time codeCharging the built-in batteryThe camera uses the built-in battery to rememberthe date and time.If [LOW INTERNAL BATTERY] (built-in battery levelis low) is displayed when the date and time areset, it means that the built-in battery is depleted.Charge the battery with the following method.Set the date and time after the battery fullycharged.1 Connect an AC adaptor to the camera.(Page 24 of Vol.1)• Leave the POWER/MODE switch of thecamera at .2 Leave the camera for approximately fourhours.• The built-in battery is charged.• Check the time code and menu operationsafter charging.If the date and time are not remembered aftercharging, the built-in battery needs to be replaced.Consult your dealer.Setting the time codePerform various time code related settings with thefollowing items on the setup menu [TC/UB SETUP]screen. (Page 87)• [TC MODE] item• [TCG] item• [TC PRESET] item• [UB MODE] item (DV mode only)Specifying the time code ([TCPRESET] item)Set the time code value with the [TC PRESET]item to record any value as the time code value atthe start of recording.1 Turn the POWER/MODE switch of thecamera . (Page 27 of Vol.1)2 Select the [TC PRESET] item on the setupmenu [TC/UB SETUP] screen.• Menu operation (Page 28 of Vol.1)• Operations can be performed with buttons onthe remote control that correspond to those onthe camera. For details, see “Remote control”(Page 21 of Vol.1).3 Tilt the OPERATION lever in the < >direction to move to [YES], and push theOPERATION lever.
