Panasonic AG-HPG10P Operating Instructions Manual

Also see for AGHPG10 - MEMORY CARD PORTABLE RECORDER: Operating instructions Brochure & specs

Contents

Panasonic AG-HPG10P Operating Instructions Manual Manual pdf 54 page image

54Copying data from P2 cards to the hard drive (USB HOST mode) (continued)Exporting data to a hard drive in 1-card incrementsIf you are using a TYPE S hard drive, you can export all the data on one P2 card at a time to the harddrive (write data from P2 cards onto the hard drive). Before proceeding, use the unit to format the harddrive. The data of up to 23 cards can be stored on the hard drive. The computer or other device used willrecognize each P2 card from which the data is exported to be a separate drive.1 Switch to the USB HOST mode.2 Connect the USB hard drive.Format the hard drive if it has not already beenformatted by the unit.Refer to “Formatting the hard drive.”3 Insert the P2 card.4 Press [MENU].5 Using [STOP], [PLAY] and [STILL], select“HDD” – “EXPORT”, and press [STILL].6 Select the number of the P2 card slot wherethe P2 copy source card was inserted, andpress [STILL].7 Select “YES”, and press [STILL].• A progress bar is displayed while the data isbeing exported.• To stop exporting the data at any time, pressthe [STILL], move the cursor to “YES” on the“CANCEL” confirmation display, and press[STILL].• It will take less time for the exporting to becompleted if you set it up so that verificationof the two sets of data is not required duringexporting. To do this, set the menu “HDD”– “SETUP” – “VERIFY” to “OFF”.• The copying of the P2 card data will also beterminated if the process is aborted duringverification of the two sets of data.When the exporting is completed, “COPYCOMPLETED!” appears on the screen.