105 EditingConnections to the DVCPRO/DV connectorRecording signals input to theDVCPRO/DV connector1 Connect a 1394 cable (DV cable).• “Precautions in 1394 connections” (Page 107)• Make sure that the signal format of thecamera-recorder and the connected device isthe same.2 To route inputs via the IEEE1394 interface,set the menu option REC SIGNAL in theSYSTEM SETUP screen to 1394.• To use HD (1080i, 720P) set the menu optionREC FORMAT in the SYSTEM SETUPscreen to DVCPRO HD/60i (DVCPROHD/50i) or DVCPRO HD/60P (DVCPROHD/50P).The AVC-Intra format and DVCPRO HDnative recording do not allow input via theIEEE1394 interface.3 Check that video from the IEEE 1394interface is displayed in the viewfinder orLCD monitor, and press the START/STOPbutton to begin recording.4 Press the START/STOP button again to stoprecording.• Signals that have the same format as thatset in the menu options SYSTEM MODEand REC FORMAT in the SYSTEM SETUPscreen should be input to the IEEE1394interface. A signal in a different format willnot be correctly recorded on a P2 card.Video and audio recording and EE typevideo and audio of signal inputs other than1x speed playback signals may not work.· “Errors and warnings” (Page 126)• Audio signal inputs are input signals fromthe DVCPRO/DV connector.• 32 kHz/4CH (12 bit) audio signals input viathe IEEE1394 interface are recorded as48 kHz/4CH (16 bit) on a P2 card.• It is not possible to use the GENLOCK INconnector to synchronize to an externalreference signal.• Signals output from the VIDEO OUTor AUDIO OUT connectors differ fromactual input signals. Use such signals formonitoring.• The following functions do not operate.· Pre-recording function· Loop recording function· Interval recording and one-shot recordingfunction· One-clip recording function• As well as those displayed in blue, thereare other items on the setting menu forwhich the setting value cannot be changed.However, this is not a fault and these itemsare not related to this function.Time Code and User Bits• When input from the IEEE1394 interface isselected, the time code and user’s bit input fromTC IN/OUT cannot be recorded on P2 card.• When input from the IEEE1394 interface isselected, the time code output from TC IN/OUTis not synchronized with the video signal outputfrom the VIDEO OUT terminal.
