– 22 –Controls and Their Functions… TCG (time code selector) switchThis is used to set the running mode of the internal time code generator.F-RUN: This position is used when the time code is to be advanced continuously regardlessof the VTR’s operation.Set to this position when aligning the time code with the actual time or locking thetime code to an external source.SET: This position is used for setting the time code or user’s bit.R-RUN: This position is used when the time code is to be advanced only while recording isin progress. The time code will be recorded continuously on a tape with a succes-sion of unedited shots.Warning/Status Display SectionTally lampThis is activated when the TALLY switch À is at HIGH or LOW, and it lights during recordingby the VTR section. It flashes in the same way as the REC lamp inside the viewfinder to warnthe operator. The brightness when lighted can be selected using the TALLY switch (HIGH orLOW).À TALLY switchThis controls the tally lamp .HIGH: The tally lamp is made brighter.OFF: The tally lamp is extinguished.LOW: The tally lamp is made darker.à Back tally lampThis functions in the same way as the tally lamp when the back tally switch Õ is set toON.Õ Back tally switchThis controls the back tally lamp Ã.ON: The back tally lamp operates.OFF: The back tally lamp does not operate.Œ WARNING lampThis flashes or lights when trouble occurs in the VTR section.œ LIGHT switchON: This illuminates the display window –.OFF: This extinguishes the display window illumination.– Display windowThe warnings related to the VTR section, remaining battery level, sound level, time data, etc.are displayed in this window.œ–Œ…ÀÃÕ
